Kawasaki Mule Knocking Noise - It noticeable above 20 mph. almost like a clutch engaging and disengaging, dealers. My 2008 kawasaki mule 610 makes a loud knocking noise in 2wd coming from under the front driver's side. It is throwing fluid on the inside of the driver's front tire after operating 1. 8 miles. I've worked this mule from the front final drives to the rear to include the electrical, heads, carb, etc. it is currently running pretty good, as i am slowly but surely working out all the bugs. But what i think to be the final obstacle is this knocking or chattering sound if. The knocking sound comes from the engine pulley, right side of the machine. It isn't quite tight enough and it rattles, and sounds exactly like a main bearing knock. I have a 2005 kawasaki mule 3010 that the front end makes a knocking noise, like its binding up. The tires are all properly inflated. I put it up on jacks, put it in gear and everything. Only 8 hours on the mule. but i immediately noticed this problem that others have had. Trying to decide if this is just a noise problem, or something that could development into. My recommendation is to do the valve adjustment, and i expect the noise will go away. Pull the torque converter cover and check everything to be sure center to center. I have a 3010 kawasaki mule 4x4 utv that i purchased new in 2002. Had no drive train problems until 2008, when it started making a loud banging noise whenever i engage. Had a knocking sound in my mule mx after changing the oil. Apparently, if over filled, oil will spill into the bottom of the air filter case. Unusual engine noises can be an indication of underlying problems with your kawasaki muleโค identifying the specific noise and its source is crucial for effective.
It noticeable above 20 mph. almost like a clutch engaging and disengaging, dealers. My 2008 kawasaki mule 610 makes a loud knocking noise in 2wd coming from under the front driver's side. It is throwing fluid on the inside of the driver's front tire after operating 1. 8 miles. I've worked this mule from the front final drives to the rear to include the electrical, heads, carb, etc. it is currently running pretty good, as i am slowly but surely working out all the bugs. But what i think to be the final obstacle is this knocking or chattering sound if. The knocking sound comes from the engine pulley, right side of the machine. It isn't quite tight enough and it rattles, and sounds exactly like a main bearing knock. I have a 2005 kawasaki mule 3010 that the front end makes a knocking noise, like its binding up. The tires are all properly inflated. I put it up on jacks, put it in gear and everything. Only 8 hours on the mule. but i immediately noticed this problem that others have had. Trying to decide if this is just a noise problem, or something that could development into. My recommendation is to do the valve adjustment, and i expect the noise will go away. Pull the torque converter cover and check everything to be sure center to center.